Skip to content

Licensed, 14 years in business. Free roof inspection

(317) 316-3479
(317) 316-3479

ServicesTPO Roofing

TPO Roofing in Rocky Ripple

TPO is the right roof for the flat parts of your home: a back porch, a garage, a sunroom or a low addition. We weld the seams into one watertight sheet. Then we come back afterward to check it and show you how to look after it.

Roofer kneeling on a white TPO membrane flat roof, heat-welding a seam with a hot-air welder near a roof drain and parapet wall, bare trees and a house beyond

A flat roof that stays dry

TPO is a single-ply membrane, a tough white sheet made for roofs too flat for shingles. Shingles shed water by overlapping. On a pitch lower than about 3 in 12, water sits long enough to work its way under them. TPO keeps it out a different way. We fuse the seams with hot air, so the whole roof acts like one piece.

We put new TPO on porches, garages, dormers and additions. We replace worn roll roofing and old tar-and-gravel sections. We also fix leaks in TPO that is already up there. If the main roof needs work too, we look at both on the same visit.

Flat roofs reward a little attention. So after the job we come back, check the seams and drains, and tell you what to watch for. Most flat roof problems are cheap to fix when someone spots them early.

What the work includes

Tear-off and deck check

We strip the old roofing down to the wood. We walk the deck and press on soft spots. Rotted plywood gets cut out and replaced before anything new goes down.

Insulation and tapered board

Rigid insulation board goes over the deck. Where water has been pooling, we use tapered board to give the roof a slight pitch toward the edge or drain.

Heat-welded seams

Each overlap is fused with a hot-air welder. When the seams cool, we run a probe along every one to find gaps.

Wall and edge flashing

Where a low roof meets a wall of your home, the membrane runs up the wall and gets sealed with a termination bar and metal flashing. Pipes and vents get fitted boots.

The tie-in to your shingles

The spot where a flat section meets a sloped shingle roof is where most leaks start. We lap and seal that joint with extra care, because it takes the water coming off the main roof.

Return visit and care notes

Once the work has settled in, we come back to look it over. You get plain notes on keeping drains clear and what damage looks like.

Signs your flat roof needs TPO

  • Water still there two days later

    Some puddling during a storm is normal. If water is still sitting 48 hours later, the roof has sagged or was never pitched right.

  • Cracked or blistered roll roofing

    Old roll roofing and asphalt coatings dry out, crack and bubble. Once that starts, patches tend to buy only a season or two.

  • Stains under a porch or addition

    A brown ring on the ceiling of a sunroom or porch often traces back to a flat section above it.

  • Shingles on a roof that is too flat

    Shingles laid on a very low pitch leak at the laps, no matter how new they are. TPO is the fix.

  • Ice at the edge every winter

    Indiana freeze-thaw cycles push meltwater into any open seam. Ice ridges along the edge of a flat roof mean water is backing up.

How the job goes

  1. 1

    Free inspection

    We get on the roof, measure it and check the slope and the deck. You get photos of what we found and a line-item estimate.

  2. 2

    Protect the area

    We cover plants, patios and anything near the work. On a porch roof we keep the doorway below clear so you can still use it.

  3. 3

    Tear-off, deck and insulation

    Old roofing comes off and bad wood gets replaced. The insulation and any tapered board go down the same day the deck is open, so it is never left bare.

  4. 4

    Membrane, welding and flashing

    We roll out the TPO, weld and probe the seams, and finish the walls, edges and pipes. Most porch and garage roofs are done in a day.

  5. 5

    Cleanup and the check-back

    We haul off debris and sweep the yard with a magnet for nails. Later we come back to look at the seams and drains with you.

What sets the price

Every flat roof is priced on what we find up there. The written estimate breaks the job into separate lines for membrane, insulation, wood and flashing, so nothing is lumped together. Financing is available if that helps.

Size of the roof
Membrane, insulation and labor all scale with square footage.
Condition of the deck
Rotted plywood under an old leak adds material and time. We show you photos before we replace any.
Tapered insulation
A roof that already drains well needs flat board. One that ponds needs tapered board, which costs more.
Walls, pipes and edges
Each wall tie-in, vent and drain takes hand work. A small roof with lots of details can cost more than a bigger plain one.
Access and membrane thickness
A second-story roof over a porch is harder to reach than a garage. Thicker membrane costs more and holds up better to foot traffic.

TPO roofing questions

Something not covered here? (317) 316-3479

How long does a TPO roof last?

Installed well and looked after, TPO commonly lasts 20 years or more. The seams and flashing decide most of that. Keeping drains clear and fixing small punctures early adds years.

Can I walk on it?

Yes, for checking drains or cleaning off leaves. Wear soft-soled shoes and don't drag furniture or grills across it. If you want a patio on it, we can add walk pads.

Can you put TPO over my old flat roof?

Sometimes. If there is only one layer and the deck underneath is dry and solid, a recover can work. If we find wet insulation or soft wood, we will tell you a tear-off is the better choice.

Hail or a branch punctured my flat roof. Can you help with the claim?

Yes. We work with homeowners and insurance companies on storm damage claims. We photograph the punctures and measure the hurt area, so you have a clear record in hand when the adjuster comes out. Our Storm Damage Repair page has more on how that works.

What should I do to take care of it?

Clear leaves from the drains and edges in spring and fall. Following a big storm, look for anything sharp sitting on the surface. We go over all of this on our return visit, and you can call us if something looks off.

Let us take a look at your flat roof

We will check the slope, the seams and the deck, and give you a straight answer on repair or replacement. No cost for the visit.